No idea at the moment.
DOUBLE POSTING will not get the problem solved any quicker - in fact it will have the opposite effect.
How are you accessing the RPi when the keyboard is not attached? Via SSH?
In both cases the correct modules are being loaded.
How is your USB Hub powered? If unpowered - try powering it (It's a long shot)
Also can you try with a USB mouse and see if you get the same results.
Have no Hub. Only connect to this 2 Ports on pi. If i try without Keyboard i Logged in via ssh on Computer.
After work i will try usb mice and usb touch Controller...
I Have no idea where my Mistakes Are.
I wondering that there is no one with Same Problems...
@Marco
1) Can you confirm that with the keyboard - everything works on the touchscreen as expected!
2) What is the output of lsusb with the keyboard attached.
3) I assume all is correct in XBMC -> System -> System -> Input Devices? Maybe you could look there.
Apart from that - I am at a loss - could you try moving the USB connection to the other slot and see if that makes a difference (Clutching at straws I'm afraid).
I can't see why it doesn't work without the keyboard.
@
mk01 - Any ideas?
1.) yes i can with mouse or keyboard everything works fine, as it should be...
2.)
Terminal
xbian@xbian ~ $ lsusb
Bus 001 Device 002: ID 0424:9514 Standard Microsystems Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 001 Device 003: ID 0424:ec00 Standard Microsystems Corp.
Bus 001 Device 004: ID 0eef:0001 D-WAV Scientific Co., Ltd eGalax TouchScreen
Bus 001 Device 005: ID 413c:2003 Dell Computer Corp. Keyboard
3.) input device is a CEC Adapter....
not better if i chance usb slot
I've no idea what is going wrong.
Can you try a wireless KB (borrow one if necessary) and see if that works.
If it does, you could buy a cheap mini RF KB and just use that in the car. The KB could be anywhere!!
Use that until a better fix is forth coming.
I had idea but forgot between the site was down & up
)
will think again