Forum

Hello,

I would like to know how to calibrate the eGalax USB touch screen which is natively suportted in
Xbian 1 beta 2.

I don't know which file I have to edit or which program I have to run to make it work properly.

Thanks per advance for your help

I have found these configuration files : hwcalib_xy and swap_xy
in sys/modue/usbtouchscreen/parameters
but I don't what to write in them; for the moment they only contain a letter : N

On my usb touch screen, the y axe is inverted

no idea about the "hwcalib_xy"

but for "swap_xy" you can try putting "Y"

but you check forum a bit there is specific thread with conf & setup scripts to do all for you.

Buongiorno a tutti.
Ho un RPI, una SD con Raspbian e un'altra SD con Rapsbmc (KODI) e questo LCD:
http://www.banggood.com/1024-x-600-7-Inch-LCD-Touch-Screen-With-Driver-Board-Kit-For-Raspberry-Pi-p-953767.html
Voglio installare il touch su entrambe.
Essendo nuovo di RPI e non conoscendo Linux, Vi chiedo se potete indicare ad un neofita come me la sequenza delle istruzioni da eseguire per l'installazione del display sulle due distro.
Grazie
---------------------------------------------------------------------------------------------
Goodmorning everyone.
I have an RPI, a SD whit Raspbian and another with Rapsbmc (KODI) and this LCD: http://www.banggood.com/1024-x-600-7-Inch-LCD-Touch-Screen-With-Driver-Board-Kit-For-Raspberry-Pi-p- 953767.html
I want to install the touch on both.
Being new to RPI and not knowing Linux, I'm wondering if you can tell a neophyte like me sequence of instructions to be executed for the installation of the display on the two distros.
Thank you