Forum

Hallo, i have a problem with egalax resistive 7" calibration.
i tried to calibrate with the ts_calib and in the ts_test works good, but in the xbmc doesn't work as expected.
with raspbmc i have the same exact problem but no help from their forum.
with xbian i have 2 problems:
when i touch the screen with the finger, the system became almost unresponsive, i have to kill uimapper from ssh to make it work again.

anyway, the calibration is not correct, if i move the finger up 2 cm, the cursor goes up 4 cm, if i move the finger left 2 cm, the cursor goes right 4cm, if i click the center of the screen, the cursor is...i don,'t know, somewhere out of the screen...

i'm going to put my raspberry into the trash.

please help me

This is beyond most of our support capabilities since few use a touchscreen.

It may take awhile for help on this issue, just wanted you to know we aren't ignoring you.

Have you seen this thread:

http://forum.xbian.org/showthread.php?tid=1087

(15th Oct, 2014 07:14 PM)f1vefour Wrote: [ -> ]This is beyond most of our support capabilities since few use a touchscreen.

It may take awhile for help on this issue, just wanted you to know we aren't ignoring you.

Have you seen this thread:

http://forum.xbian.org/showthread.php?tid=1087

thank you, i've read almost every guide i've found in internet
i think that the problem is that the resolution of the monitor is not well recognized by xbmc gui or something similar

a while ago (months) we changed to that egalaxy support

https://github.com/xbianonpi/xbian-package-xbmc/blob/master/patches/rpi/00-eGalaxytouch/README.xbmc

http://www.engineering-diy.blogspot.sk

(6th Dec, 2014 07:49 PM)mk01 Wrote: [ -> ]a while ago (months) we changed to that egalaxy support

https://github.com/xbianonpi/xbian-package-xbmc/blob/master/patches/rpi/00-eGalaxytouch/README.xbmc

http://www.engineering-diy.blogspot.sk

in your site i see that you have an addon for xbmc with touch calibration, is possible to take only that addon and use it in xbmc? which file i have to take?

(17th Jan, 2015 10:58 AM)wash Wrote: [ -> ]

(6th Dec, 2014 07:49 PM)mk01 Wrote: [ -> ]a while ago (months) we changed to that egalaxy support

https://github.com/xbianonpi/xbian-package-xbmc/blob/master/patches/rpi/00-eGalaxytouch/README.xbmc

http://www.engineering-diy.blogspot.sk

in your site i see that you have an addon for xbmc with touch calibration, is possible to take only that addon and use it in xbmc? which file i have to take?

done, doesn't work at all.