Forum

Full Version: no network tab to enable wifi
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
Hmmm, I suppose this is hardcoded.

Probably you have to rewrite splash
Wow, I have just installed 18.3 and I had the hardest time finding where to configure the wifi. I'm a complete newbie to this, but finally found the network eth0 had up and down carrots and needed to be changed to wlan0 and then I could scan for networks with my rpi3.

I think that could be made a little easier for the non-linux users.

(30th Aug, 2019 03:34 PM)redjeep0 Wrote: [ -> ]Wow, I have just installed 18.3 and I had the hardest time finding where to configure the wifi. I'm a complete newbie to this, but finally found the network eth0 had up and down carrots and needed to be changed to wlan0 and then I could scan for networks with my rpi3.

I think that could be made a little easier for the non-linux users.

I realize this is the wrong thread, but I can't post a new thread, yet and this is the closest I could find. Hopefully this helps someone else?
(30th Aug, 2019 03:34 PM)redjeep0 Wrote: [ -> ]Wow, I have just installed 18.3 and I had the hardest time finding where to configure the wifi. I'm a complete newbie to this, but finally found the network eth0 had up and down carrots and needed to be changed to wlan0 and then I could scan for networks with my rpi3.

I think that could be made a little easier for the non-linux users.

This has nothing to do with Linux.

Btw, there is a easy way to setup wlan before initial boot:

Prepare a wpa_supplicant.conf file and put it into the boot partition, as described for example here, Step 4. Add network info

That's it Big Grin

Quote:
(30th Aug, 2019 03:34 PM)redjeep0 Wrote: [ -> ]Wow, I have just installed 18.3 and I had the hardest time finding where to configure the wifi. I'm a complete newbie to this, but finally found the network eth0 had up and down carrots and needed to be changed to wlan0 and then I could scan for networks with my rpi3.

I think that could be made a little easier for the non-linux users.

I realize this is the wrong thread, but I can't post a new thread, yet and this is the closest I could find. Hopefully this helps someone else?

Now you can create new threads Smile
Pages: 1 2
Reference URL's