I did a fresh install of ver 1.05a and got nothing but a black screen
So, I modified config.txt to be:
Hdmi_safe=1
Now it's running, but the picture occupies the middle of the screen with giant, wide, black bars on the right and left.
So, what other HDMI settings should I use to get a full HD screen ?
Thanks
please read Video section
http://elinux.org/RPiconfig
and follow the instructions
edit:if you struggle find the solution please report back
(19th Apr, 2013 03:46 AM)rikardo1979 Wrote: [ -> ]please read Video section
http://elinux.org/RPiconfig
and follow the instructions
edit:if you struggle find the solution please report back
Well, I am getting close.
Truth be told, the instructions are a bit difficult to decipher.
Where I am now is that a group=1 and mode=5 is very close.
The picture fills the screen and is pretty sharp.
The only problems that I have are that the display spills off the edges of the screen and I don't know what to do. Example in that the home button for XBMC is almost out of reach.
It might be another setting that I could use to shrink the display a little bit but I am hoping that you can point me to the correct setting. I read them a bit and they don't give me a clue.
So close, so close.
Thanks again
Oh yeah, before I forget, do the licenses for mpg2 and wvc1 have any effect on watching videos or sound ?
I didn't buy them but will,if needed.
look for my post
here
also what is your setup ?all the HW in connection chain, your settings in XBMC, config.txt
all the info you can provide
see my signature