+- Forum (http://forum.xbian.org)
+-- Forum: Software (/forum-6.html)
+--- Forum: Additional Packages (/forum-22.html)
+--- Thread: IR ,how to set it up? (/thread-2000.html)
IR ,how to set it up? - lukeg01 - 12th Jan, 2014 04:21 AM
hello
i like to know how to set up ir on xbian, couldn't find a good guide so,
i not very fammiliar with linux system but i can learn...
luke
RE: IR ,how to set it up? - IriDium - 12th Jan, 2014 05:14 AM
Try here first Xbian Wiki
IR ,how to set it up? - lukeg01 - 5th Feb, 2014 06:29 AM
How to connect it(which pins) ?
RE: IR ,how to set it up? - koper89 - 5th Feb, 2014 10:33 AM
http://learn.adafruit.com/using-an-ir-remote-with-a-raspberry-pi-media-center/hardware
IR ,how to set it up? - lukeg01 - 7th Feb, 2014 05:55 AM
It goes wrong at rule 4 step 1 "
aclocal && autoheader && autoconf"
Re: RE: IR ,how to set it up? - freem@n - 7th Feb, 2014 05:00 PM
(7th Feb, 2014 05:55 AM)lukeg01 Wrote: aclocal && autoheader && autoconf"
where did you read this? are you sure you are reading the right wiki page (the one above)
RE: IR ,how to set it up? - CurlyMo - 7th Feb, 2014 06:07 PM
He's trying to compile Lirc himself. @lukeg01, why?
IR ,how to set it up? - lukeg01 - 8th Feb, 2014 06:39 AM
Because is in use apt-get and try to enter mode2 it can't find certain files
RE: IR ,how to set it up? - CurlyMo - 8th Feb, 2014 06:42 AM
Like what?
IR ,how to set it up? - lukeg01 - 8th Feb, 2014 06:47 AM
Killed him again, tried to reinstall lirc from ipod yesterday.... Killed him. Set back a backup and now: from ios KILLED IT so tomorrow I can set back a backup
A, wait a hard reboot fixed it, here the error
[attachment=302]
RE: IR ,how to set it up? - freem@n - 8th Feb, 2014 08:37 AM
by installing lirc over the existing xbian lirc package you have obviously overwritten the lircd.conf. the debug message from your shell doesn't look that good as well IMO... "Remote control support has been disabled". you should better use the btrfs-snapshot to go back to a previous version and use the default lirc package which should work fine. (at least it does for me)
IR ,how to set it up? - lukeg01 - 8th Feb, 2014 05:20 PM
We'll a reboot killed it anyway so I gonne replace it with a backup
We'll the backup included the attempt of lirc.... I'm going for a full re install, I really nead a clean start
IR ,how to set it up? - lukeg01 - 8th Feb, 2014 10:34 PM
Clean install does the same