Forum
[PROBLEM] How to install with serial console? - Printable Version

+- Forum (http://forum.xbian.org)
+-- Forum: Software (/forum-6.html)
+--- Forum: Installation (/forum-16.html)
+--- Thread: [PROBLEM] How to install with serial console? (/thread-2588.html)



How to install with serial console? - ceving - 1st Dec, 2014 02:11 AM

I connected a B+ with a serial cable to my PC. Before I have changed in the config.txt the console from

Code:
console=tty1

to

Code:
console=ttymxc0,115200

as explained here. But the only thing I see during boot is

Terminal
Uncompressing Linux... done, booting the kernel.


The initrd does not honor the boot parameter. How can I fix this?


RE: How to install with serial console? - IriDium - 3rd Dec, 2014 03:41 AM

You're following the instructions for Cubox-I

Quote:CuBox-I
cmdline paramaters

Edit the /boot/boot.src.txt file and run /boot/mks afterwards.

I don't believe there is an option for Serial Console on the Raspberry Pi.


RE: How to install with serial console? - f1vefour - 6th Dec, 2014 11:40 AM

It does but it has to be enabled in the kernel (unsure if it is), I have never gotten it to work.

http://elinux.org/RPi_Serial_Connection

I'm using one of these:

https://www.fasttech.com/p/1230400


RE: How to install with serial console? - mk01 - 6th Dec, 2014 04:26 PM

CONFIG_SERIAL_AMBA_PL011_CONSOLE

is enabled for RPI kernels. so should work.
(even have a very weak feeling someone was using that. because remember discussion how to make it permanent (for ttyX)).


RE: How to install with serial console? - f1vefour - 6th Dec, 2014 07:25 PM

Thanks for confirming mk01