+- Forum (http://forum.xbian.org)
+-- Forum: Software (/forum-6.html)
+--- Forum: Configuration (/forum-17.html)
+--- Thread: IF setting bug. (/thread-3449.html)
IF setting bug. - Skywatch - 19th Mar, 2016 07:35 PM
Probably a Kodi issue, but I cannot change the ip address of a pi 2 from within the Kodi system menu. It always returns an error message.
Works fine from xbian-config however.
RE: IF setting bug. - IriDium - 27th Mar, 2016 01:35 AM
Didn't know you could change the IP address from within Kodi itself, or do you mean Kodi-xbian-config as opposed to ssh-xbian-config?
RE: IF setting bug. - Nachteule - 27th Mar, 2016 03:11 AM
Does this happen on a fresh install or with and older installation?
Just tested with latest image on RPi3, no problem (etn0 from DHCP -> static IP 1 ->static IP 2)
RE: IF setting bug. - Skywatch - 27th Mar, 2016 07:52 AM
Iridium you are correct.
It's as old as a pi 2 version can be I suppose
This raises the question as to how often we can upgrade and how often we should reinstall everything from scratch?
RE: IF setting bug. - Nachteule - 27th Mar, 2016 09:11 AM
Quote:This raises the question as to how often we can upgrade and how often we should reinstall everything from scratch?
Very good question - but I suppose there is no answer
For me - I never did a fresh install for my 'productive' XBian's, always upgrading. So I went from Rpi1 -> RPi2 -> Rpi3, never had serious trouble
And my .kodi folder comes from XBMC 10 (Dharma)
RE: IF setting bug. - Skywatch - 31st Mar, 2016 04:45 AM
I guess that I did some fresh installs in the early days (2012-2015) but not for a while.