[SOLVED] Error when updating XBMC after clean install

[zilexa]

Just did a new install with a new SD card, using the Windows Installer 1.0a5. In the config, I selected Update, only the firmware had an update, but the log after updating showed nothing was updated.

Then I exited the config and updated XBMC like this (I expected it to update to 12.2):

Code:

xbian@xbian ~ $ sudo apt-get update
[sudo] password for xbian:
Hit http://mirrordirector.raspbian.org wheezy InRelease
Hit http://archive.raspberrypi.org wheezy InRelease
Hit http://xbian.brantje.com/ wheezy InRelease
Hit http://mirrordirector.raspbian.org wheezy/main armhf Packages
Hit http://archive.raspberrypi.org wheezy/main armhf Packages
Hit http://mirrordirector.raspbian.org wheezy/contrib armhf Packages
Hit http://xbian.brantje.com/ wheezy/main armhf Packages
Hit http://mirrordirector.raspbian.org wheezy/non-free armhf Packages
Hit http://mirrordirector.raspbian.org wheezy/rpi armhf Packages
Ign http://archive.raspberrypi.org wheezy/main Translation-en
Ign http://xbian.brantje.com/ wheezy/main Translation-en
Ign http://mirrordirector.raspbian.org wheezy/contrib Translation-en
Ign http://mirrordirector.raspbian.org wheezy/main Translation-en
Ign http://mirrordirector.raspbian.org wheezy/non-free Translation-en
Ign http://mirrordirector.raspbian.org wheezy/rpi Translation-en
Reading package lists... Done
xbian@xbian ~ $ sudo apt-get install xbian-package-xbmc -y
Reading package lists... Done
Building dependency tree
Reading state information... Done
Some packages could not be installed. This may mean that you have
requested an impossible situation or if you are using the unstable
distribution that some required packages have not yet been created
or been moved out of Incoming.
The following information may help to resolve the situation:

The following packages have unmet dependencies:
xbian-package-xbmc : Depends: upstart but it is not going to be installed
E: Unable to correct problems, you have held broken packages.

What does this mean??

update: xbmc 12.2 not supported anymore on 1.0a5 and beta1 is recommended instead of 1.0a5.