Official XBian 1.0 Beta 1.1 thread

[mk01]

(15th Jul, 2013 04:35 PM)JeHaLi Wrote:  Setting up nfs-common (1:1.2.6-4) ...
insserv: Service rpcbind has to be enabled to start service nfs-common
insserv: exiting now!
update-rc.d: error: insserv rejected the script header
dpkg: error processing nfs-common (--configure):
subprocess installed post-installation script returned error exit status 1
Errors were encountered while processing:
nfs-common
E: Sub-process /usr/bin/dpkg returned an error code (1)
root@xbian:/home/xbian#

just do "sudo "insserv -f rpcbind", then "apt-get -f install", then continue with update.

---

(15th Jul, 2013 07:36 PM)googl1 Wrote:  The tv screen said something like "rebooting now"

After that the screen stayed black, ssh didn't answer and my harddrives stayed in standby.
The green LED on the pi is blinking.
I didn't unplug or poweroff it yet.

rebooting now appears on the screen when xbian-update finishes setting up under dpkg. then it waits for apt-get and dpkg processes to finish. because system changed init (sysvinit -> upstart), runlevels are not working and reboot / shutdown either.

so we wait cca 30s, do sync and reboot -f.

then splash screen should disappear and rpi reboots. the black screen is where RPi is starting. so far so good.

during kernel loading, blinking cursor should be visible in upper left corner. as soon as kernel loads, splash should be started, first with "init process..." and in few seconds it should jump into "sd card resize" and "sd card convert".

this can take minutes, but also an hour (even more). text under progress bar is changing through the process steps. this is how it SHOULD run. you can compare your situation.

here on forum were reported cases with upgrade via remote ssh with frustration first (it rebooted, now i can't connect, even ping ...). and hour - two later rpi booted after convert.

during conversion, xbian system is not started - so no network, ping, nothing.

---

(15th Jul, 2013 07:36 PM)googl1 Wrote:  The green LED on the pi is blinking.
I didn't unplug or poweroff it yet.

Does it convert the fs do btrfs or something like that or can I just unplug it to restart it?

but this one looks like the "reboot -f" wasn't performed and is stuck still before reboot.

I would unplug & replug it.