Official XBian 1.0 Beta 1.1 thread

[mk01]

(16th Jul, 2013 07:31 PM)wifi86 Wrote:  Hi there,

I just try to update from beta 1 to the new 1.1 version and I get an error similar to the one Jehali has said but with the ifupdown interface, any ideas how to solve it? 'cos i can only think of trying a fresh install...

hard to know what you mean, but. on alpha5, eth0 wasn't listed in /etc/network/interfaces as "auto". ad1) it was working ad2) due to bugs in debians scripts, under some conditions it was even needed like this.

since upstart, this is heading back to documented workflow so if eth0 is not listed as "auto" interface, standard ifup run will not trigger it.

beta2 is correcting this (adding eth0 to "auto" to /etc/network/interfaces) so file should look like this:

Code:

auto lo
auto eth0
.
.
.

or simply

Code:

auto lo eth0

---

(16th Jul, 2013 10:10 PM)zilexa Wrote:  hmm I must have installed something in the last few months. No problem I'll try changing it to C. Just wanted to be sure it's not caused by XBian. Thanks!

more or less those errors you encountered are not affecting the program itself on the xbian.

it only means, that the output of the messages would be like as you requested, but it's not possible, because your desired format is not available.