Issues with Logitech Harmony

[f1vefour]

(7th Dec, 2013 11:58 AM)poko Wrote:  

(5th Dec, 2013 08:03 AM)CurlyMo Wrote:  Can you check if this works and post all output:

Code:

sudo modprobe mceusb
sudo modprobe lirc_dev
sudo service lirc restart
ls -Al /dev/lirc*
mode2

I have been lurking in the shadows on this thread, following along

I am on beta 2 with an HP MCE 6 remote, and a GPIO IR reciever. I have followed most of the steps on this thread and finally saw something when I ran these commands from CurlyMo, and added mceusb.conf to the lircd.conf file.

The problem is, now when I press a button on the remote, it appears that it may be inputed twice, at least when I am using the arrows. It will move over twice or up/down twice when I press the arrow buttons. Why would this be? Do I need to delete one of the lirc modules from the kernel with modprobe -r?

I did get to a point where only the arrow buttons were working but nothing else, but now other buttons seem to be working, it's just the arrows get pressed twice.

I appreciate your help!

Try stopping lircd and simply running it with no commands.

Terminal

sudo service lirc stop
sudo lircd