[HOW-TO] Installing XBIAN directly on RASPBIAN IMG

[raspi]

Hello,

I have finally installed on the sdcard by keeping filesystem on ext4 (waiting for another sdcard and I ll give a try with btrfs).

On the first boot after the automatic restart generate after the installation of xbian-update and switching package( last command), I got a message "Freeing kernel memory 132K ...".
After 1-2 min the boot go further and finally I'm able to login.

But the next manual reboot/shutdown, I got the same message "Freeing kernel memory 132K ..." and after waiting 1-2 min again, the prompt show on the tv (hdmi) but it disappears quickly (about 5 sec after) and I'm no longer able to login.

Do someone know what happening ?

Terminal

cmdline.txt
dwc_otg.lpm_enable=0 console=ttyAMA0,115200 kgdboc=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline rootwait

Terminal

cmdline.new
telnet zswap.enabled=1 zswap.compressor=lz4 sdhci-bcm2708.sync_after_dma=0 dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p2 rootflags=subvol=root/@,thread_pool=2,autodefrag,compress=lzo,commit=5 rootfstype=btrfs rootwait smsc95xx.turbo_mode=N elevator=cfq logo.nologo quiet noswap loglevel=0 mod_scsi.scan=sync partswap startevent=mountall splash nohdparm --startup-event mountall

Terminal

config.txt
#initramfs initramfs.gz 0x00a00000
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

# for more options see http://elinux.org/RPi_config.txt
emmc_pll_core=0
initial_turbo=3