XBian DEVEL and STAGING repositories

[freem@n]

(4th Mar, 2014 09:42 AM)Jingles Wrote:  1. I can't open xbian-config. Every time I boot my system or try to launch xbian-config manually i get the following message:

Code:

/usr/local/sbin/xbian-config: line 203: /run/lock/xbian-config.gui: No such file or directory

(...)

3. When running dist-upgrade the firmware upgrade fails with the information below:

Code:

xbian@sierra ~ $ sudo apt-get dist-upgrade
Reading package lists... Done
Building dependency tree      
Reading state information... Done
Calculating upgrade... Done
The following NEW packages will be installed:
  xbian-package-firmware-6q
0 upgraded, 1 newly installed, 0 to remove and 0 not upgraded.
Need to get 38.6 MB of archives.
After this operation, 164 MB of additional disk space will be used.
Do you want to continue [Y/n]? y
Get:1 http://xbian.brantje.com/ devel/main xbian-package-firmware-6q armhf 1.5.0-2 [38.6 MB]
Fetched 38.6 MB in 27s (1,411 kB/s)                                            
Create a snapshot of '/tmp/btrfs-snap/root/@' in '/tmp/btrfs-snap/root/@btrfs-auto-snap_apt-run-2014-03-03-2249'
Delete subvolume '/tmp/btrfs-snap/root/@btrfs-auto-snap_apt-run-2014-03-02-1725'
@btrfs-auto-snap_apt-run-2014-03-03-2249, 1 created snapshots, 1 destroyed snapshots, 0 warnings.
(Reading database ... 49748 files and directories currently installed.)
Unpacking xbian-package-firmware-6q (from .../xbian-package-firmware-6q_1.5.0-2_armhf.deb) ...
dpkg: error processing /var/cache/apt/archives/xbian-package-firmware-6q_1.5.0-2_armhf.deb (--unpack):
trying to overwrite '/etc/ld.so.conf.d/xbian-firmware.conf', which is also in package xbian-package-firmware 1.4.13-1
dpkg-deb: error: subprocess paste was killed by signal (Broken pipe)

Errors were encountered while processing:
/var/cache/apt/archives/xbian-package-firmware-6q_1.5.0-2_armhf.deb

Little bit at a loss >_<

1. same for me. it even was like this on stable. but now I'm on staging and devel as well. both command line and gui xbian-config refuse to start.
3. somehow I think the "...-6q" packages are exclusive for the CuBox-i platform...somebody correct me please if I'm wrong. however I'm getting the same kind of issue.