[Howto] mceusb driver with lirc protocol instead of rc-6/devinput

[ditschi]

Thanks, with the guide from post#1 I got my MCE remote working.

I still these Problems are left:
- After every reboot the remote receiver is not available (and echo lirc > /sys/class/rc/rc0/protocols fails because /sys/class/rc/rc0/protocols doesn't exists) - I have to unplug and replug the USB on my PI after every boot to make the ir being recognized

- I have to enter the echo ... command manually after I replugged the IR Receiver - rc-6 is set as default every time
How can i set lirc as default service for ir? or How to automatically execute the echo when IR is connected?

- "ir-keytable -t" isn't showing any events regardless if lirc or rc-6 is selected.
ir-keytable output shows that remote is recognized:

Code:

$ ir-keytable
    Found /sys/class/rc/rc0/ (/dev/input/event0) with:
    Driver mceusb, table rc-rc6-mce
    Supported protocols: NEC RC-5 RC-6 JVC SONY SANYO LIRC other
    Enabled protocols: LIRC
    Repeat delay = 500 ms, repeat period = 125 ms