[HOW-TO] Installing XBIAN directly on RASPBIAN IMG

[Pingu]

Hi, I just bought my first Raspberry Pi B+ and wanted to try Raspbian and Xbian together. I followed your instructions but now my Pi doesn't boot. I did this things:
1. Installed 2014-09-09-wheezy-raspbian.img
2. Updated raspi-config, updated location and keyboard settings, ran apt-get update and then apt-get upgrade, so that I got latest packages.
3. I installed lsb-release because otherwise I got error during dpkg.
4. Then I downloaded and installed xbian-package-repo_1.0.3-1_armhf.deb and followed your instructions from 1st post.

After step 3, Pi doesn't boot. There is no green light blinking, only red. After step 3 my cmdline.txt looks like this:

Code:

dwc_otg.lpm_enable=0 console=ttyAMA0,115200 console=tty1 root=/dev/mmcblk0p2 rootfstype=btrfs elevator=deadline rootwait

and config.txt like this:

Code:

initramfs initramfs.gz  0x1000000
# For more options and information see
# http://www.raspberrypi.org/documentation/configuration/config-txt.md
# Some settings may impact device functionality. See link above for details

# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

I only see colored square and then nothing. Is it possible that kernel.img got corrupted?
My power suply is ok, because when I installed only Xbian or only Raspbian they worked and I could use them.

Did I do something wrong? Did this occured because update and upgrade of Raspbian? Is it possible that latest Raspbian .img and Xbian .deb are not compatible?

Thanks for any feedback.