Xbian won't pull IP address on wireless

[josch]

I just came over this thread and got the same problem.

I already posted it in the RC3 thread, but maybe I should continue right here for a better overview.

(25th Sep, 2014 06:11 PM)josch Wrote:  [...]

Again, I can scan for wireless networks and also do find my router. But the connection test afterwards
never ends and wlan0 won't get a IP. It just keeps saying "Please wait. Trying to connect to Router".

Here are the outputs from iwconfig and ifconfig:

Code:

xbian@xbian ~ $ sudo iwconfig
wlan0     IEEE 802.11bgn  ESSID:"Router"
          Mode:Managed  Frequency:2.427 GHz  Access Point: 1C:C6:3C:42:EE:DA
          Bit Rate=72.2 Mb/s   Tx-Power=20 dBm
          Retry short limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=70/70  Signal level=-38 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:97   Missed beacon:0

dummy0    no wireless extensions.

lo        no wireless extensions.

eth0      no wireless extensions.

Code:

xbian@xbian ~ $ sudo ifconfig
eth0      Link encap:Ethernet  HWaddr b8:27:eb:d7:c1:0c
          inet addr:192.168.2.103  Bcast:192.168.2.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:372 errors:0 dropped:0 overruns:0 frame:0
          TX packets:307 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:34826 (34.0 KiB)  TX bytes:46419 (45.3 KiB)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:65536  Metric:1
          RX packets:42 errors:0 dropped:0 overruns:0 frame:0
          TX packets:42 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:2477 (2.4 KiB)  TX bytes:2477 (2.4 KiB)

wlan0     Link encap:Ethernet  HWaddr d8:5d:4c:98:eb:7a
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:13 errors:0 dropped:0 overruns:0 frame:0
          TX packets:9 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:1134 (1.1 KiB)  TX bytes:2822 (2.7 KiB)

So, it looks like it's connected to "Router" but it won't get any IP.
As I said, in RC2 wifi is working fine.

Would be really nice if someone could support me to get my wifi working with RC3.
Thank you very much!

Code:

xbian@xbian ~ $ lsusb
[...]
Bus 001 Device 007: ID 0cf3:9271 Atheros Communications, Inc. AR9271 802.11n
[...]

Code:

xbian@xbian ~ $ lsmod
Module                  Size  Used by
[...]
ath9k_htc              46756  0
ath9k_common            7047  1 ath9k_htc
ath9k_hw              387652  2 ath9k_common,ath9k_htc
ath                    17332  3 ath9k_common,ath9k_htc,ath9k_hw
mac80211              293146  1 ath9k_htc
cfg80211              172442  4 ath,ath9k_common,mac80211,ath9k_htc
led_class               2669  1 ath9k_htc
[...]

It's a fully updated (today) RC3 and isc-dhcp-client is already the newest version.

Can I deliver any logs or something to help facing the problem?

Cheers