[PROBLEM] Samsung CEC

[mk01]

it was broken in libcec a bit before we fixed it all. now it should work (speaking of AS). the behaviour you describe is consistent with the wrong PA as you say.

actually "active source" command and with it stored info is the only CEC function dependent on PA and not LA. because the TV at the end switches to HDMI port, not virtual logical address. if the LA get's changed during daily lifecycle and normal media/tv use incorrectly (co without also the physical connected port) - imagine on start we set 2100 correctly and send AS. Tv knows, that we are active and that we are connected in HDMI1 of denon and denon in HDMI2 of TV. later you watch BD or TV (so TV changes from HDMI2 to another one). then you choose back XBMC... If RPI sent info in-between that its PA changed - TV will rewrite its memory that XBMC is not at 2100 anymore but XXX. And once you click XBMC hoping for it back, TV changes to XXXX instead of 2100. but TV still sees XBMC name on the bus (although not active anymore and as you use tools->XBMC, TV actually asks the "other" XBMC of its PA, XBMC sends 2100 and that's why it works again.

so...
I don't need logs anymore, only check please if again for the messed messages where your RPI suddenly sends LA change and the "race" starts again.

I'm just compiling for you libCEC with the callback to PA change deactivated, so after load it should never consider its PA be changed. will post link shortly.