[SOLVED] Problem with performance governor

[mpnico]

Hi,

I tried the testing XBMC RC3 & new firmware and everything seems to work until I tried some high bitrate + DTS movie. I just saw that overclocking is not working anymore.

I don't know if it's a problem with new firmware, I didn't try before upgrading firmware

My config.txt is :

Code:

arm_freq=900                                                                                                                                                                                  
core_freq=375                                                                                                                                                                                
disable_overscan=1                                                                                                                                                                            
gpu_mem_256=128                                                                                                                                                                              
gpu_mem_512=128                                                                                                                                                                              
sdram_freq=450                                                                                                                                                                                
over_voltage=0                                                                                                                                                                                
                                                                                                                                                                                              
hdmi_ignore_cec_init=1                                                                                                                                                                        
initial_turbo=30

cpufreq detects my overclocking :

Code:

xbian@xbian:~# dmesg |grep cpufreq                                                                                                                                                            
[    1.190855] bcm2835-cpufreq: min=700000 max=900000 cur=900000

but the arm freq while watching movies is stuck @ 700 Mhz :

Code:

xbian@xbian:~# sudo cat /sys/devices/system/cpu/cpu0/cpufreq/cpuinfo_cur_freq                                                                                                                
700000

If i switch to ondemand governor, the arm goes @ 900 Mhz on load and the movie plays fluently.

Does anybody have the same problem ?

Thx.