[PROBLEM] Trouble getting lircd to work as expected, also is something else handling IR input?

[Msprg]

Thank you for getting me into the right direction:

1. I didnt know about README.overlays, there is SO much useful information.
2. My previous steps were from official XBian Wiki: http://wiki.xbian.org/doku.php/remotes and so IF you say what I was doing was outdated, that means the Wiki is outdated, at least that particuliar article, just so you know I only did what was written in the official sources. (So it would be about time to get the Wiki updated, but I am definitely not saying its your job, just bringing it up to attention...)


Now, with enabled gpio-ir, Im back to kodi recognizing that few keys on my remote I mentioned in one of my posts in beginning (arrow keys, power button key, and few others). That explains why I got to configuration where kodi receieved some keys 2 times, because gpio-ir as well as lirc were sending events.

So now the question is: How do I (map) get all buttons on the remote to work? Do I need dev lird for that? If so, do I need anything to the apt sources list (devel repo) or is it just package whit differrent name (something along like xbian-lirc-dev)?


Thank you for your time, you are very helpful for me, and I can learn so much things from you!

Edit: Wow, I just accidentaly observed, that my activity lights on my switch to which RPI with running XBian is connected, are rapidly blinking while I am holding ANY key on the remote (and ir-keytable registers it). I am sure the ACT are blinking because it is 100% replicable. Does it use network for something??

Also keytable-ir -t shows that ALL of my remote key presses are registered, but only those few, as descibed above, are causing some visible and meaningful response, IDK what do I do next...?