[PROBLEM] freezes after a certain time of running

[kanecharles]

(16th Nov, 2014 10:24 PM)dexter2111 Wrote:  Hi , mk01

I did not find it " turn off the TV standby mode with screensaver "
I have only:
in xbmc
Turn CEC capable TV OFF with screensaver = disable
Turn CEC capable TV OFF on RPi shutdown = disable
Turn CEC capable TV ON when XBMC exits = enable
XBMC Dynamic Priority = enable
lower nice priority = 7
higher nice priority = -3

in system\connectiivity:
Force HDMI output when no tv is identified = enable
Ignore HDMI output even if a tv is connected = disable
Ignore CEC init,,preventing wakeup of tv at reboot = disable
Disable CEC = disable
Disable overscan = disable

when i reboot the Xbian, the TV switches to HDMI(where is connected the RPi) via simplink.
If i turn the tv on/off (the RPi is connected and power up)can no longer control the RPi via remote control.
When was power up via TV usb , there were no problems.
But it was a forced shutdown of the RPI, and happened to be the SD card corrupt.
Sorry for my bad bad english.

Some points to note of time calculator:
The settings related to CEC and HDMI output in XBMC and the connection system seem to be set up correctly. However, there are still problems with controlling the Raspberry Pi with the TV remote when the TV is turned on/off.
SD card damage due to forced shutdown can be a separate problem. You can try using a new SD card or recheck the SD card to ensure system integrity.
Additionally, you may want to check the HDMI cable, HDMI port on the Raspberry Pi, and the TV to ensure a stable connection.