Hauppauge 950Q how-to-install request

[DLK]

Thanks for all of the effort you've put into helping me out.

This appears to work:

Code:

xbian@xbian ~ $ sudo modprobe xc5000
[sudo] password for xbian:
xbian@xbian ~ $ sudo modprobe au0828
xbian@xbian ~ $ sudo modprobe au8522_common
xbian@xbian ~ $ sudo modprobe au8522_decoder
xbian@xbian ~ $ sudo modprobe au8522_dig
xbian@xbian ~ $ lsmod
au8522_dig              7039  1
xc5000                 14412  2
au8522_decoder          6913  1
au8522_common           5708  2 au8522_decoder,au8522_dig
au0828                 39780  0

usb 1-1.3.2: new high-speed USB device number 8 using dwc_otg
usb 1-1.3.2: New USB device found, idVendor=2040, idProduct=7200
usb 1-1.3.2: New USB device strings: Mfr=1, Product=2, SerialNumber=10
usb 1-1.3.2: Product: WinTV HVR-950
usb 1-1.3.2: Manufacturer: Hauppauge
usb 1-1.3.2: SerialNumber: 4035034187
au0828: i2c bus registered
tveeprom 2-0050: Hauppauge model 72001, rev B4F0, serial# 8502347
tveeprom 2-0050: MAC address is 00:0d:fe:81:bc:4b
tveeprom 2-0050: tuner model is Xceive XC5000 (idx 150, type 76)
tveeprom 2-0050: TV standards NTSC(M) ATSC/DVB Digital (eeprom 0x88)
tveeprom 2-0050: audio processor is AU8522 (idx 44)
tveeprom 2-0050: decoder processor is AU8522 (idx 42)
tveeprom 2-0050: has no radio, has IR receiver, has no IR transmitter
hauppauge_eeprom: hauppauge eeprom: model=72001
au8522 2-0047: attaching existing instance
au8522_decoder attach existing instance.
tuner 2-0061: Tuner -1 found with type(s) Radio TV.
xc5000 2-0061: attaching existing instance
xc5000: Successfully identified at address 0x61
xc5000: Firmware has not been loaded previously
au8522 2-0047: attaching existing instance
xc5000 2-0061: attaching existing instance
xc5000: Successfully identified at address 0x61
xc5000: Firmware has not been loaded previously
DVB: registering new adapter (au0828)
usb 1-1.3.2: DVB: registering adapter 0 frontend 0 (Auvitek AU8522 QAM/8VSB Frontend)...
Registered device AU0828 [Hauppauge HVR950Q]

Thanks again-Dan