[PROBLEM] Touchscreen calibration is wrong and i'm going crazy.

[wash]

Hallo, i have a problem with egalax resistive 7" calibration.
i tried to calibrate with the ts_calib and in the ts_test works good, but in the xbmc doesn't work as expected.
with raspbmc i have the same exact problem but no help from their forum.
with xbian i have 2 problems:
when i touch the screen with the finger, the system became almost unresponsive, i have to kill uimapper from ssh to make it work again.

anyway, the calibration is not correct, if i move the finger up 2 cm, the cursor goes up 4 cm, if i move the finger left 2 cm, the cursor goes right 4cm, if i click the center of the screen, the cursor is...i don,'t know, somewhere out of the screen...

i'm going to put my raspberry into the trash.

please help me

[f1vefour]

This is beyond most of our support capabilities since few use a touchscreen.

It may take awhile for help on this issue, just wanted you to know we aren't ignoring you.

Have you seen this thread:

http://forum.xbian.org/showthread.php?tid=1087

[wash]

(15th Oct, 2014 07:14 PM)f1vefour Wrote:  This is beyond most of our support capabilities since few use a touchscreen.

It may take awhile for help on this issue, just wanted you to know we aren't ignoring you.

Have you seen this thread:

http://forum.xbian.org/showthread.php?tid=1087

thank you, i've read almost every guide i've found in internet
i think that the problem is that the resolution of the monitor is not well recognized by xbmc gui or something similar

[mk01]

a while ago (months) we changed to that egalaxy support

https://github.com/xbianonpi/xbian-package-xbmc/blob/master/patches/rpi/00-eGalaxytouch/README.xbmc

http://www.engineering-diy.blogspot.sk

[wash]

(6th Dec, 2014 07:49 PM)mk01 Wrote:  a while ago (months) we changed to that egalaxy support

https://github.com/xbianonpi/xbian-package-xbmc/blob/master/patches/rpi/00-eGalaxytouch/README.xbmc

http://www.engineering-diy.blogspot.sk

in your site i see that you have an addon for xbmc with touch calibration, is possible to take only that addon and use it in xbmc? which file i have to take?

[wash]

(17th Jan, 2015 10:58 AM)wash Wrote:  

(6th Dec, 2014 07:49 PM)mk01 Wrote:  a while ago (months) we changed to that egalaxy support

https://github.com/xbianonpi/xbian-package-xbmc/blob/master/patches/rpi/00-eGalaxytouch/README.xbmc

http://www.engineering-diy.blogspot.sk

in your site i see that you have an addon for xbmc with touch calibration, is possible to take only that addon and use it in xbmc? which file i have to take?

done, doesn't work at all.