beta2 ongoing development

[f1vefour]

(1st Aug, 2013 05:10 AM)mk01 Wrote:  

Code:

init: xbmc post-start process (1082) terminated with status 1
init: xbmc main process (1081) killed by TERM signal
lirc_dev: IR Remote Control driver registered, major 248
lirc_rpi: module is from the staging directory, the quality is unknown, you have been warned.
lirc_rpi lirc_rpi.0: lirc_dev: driver lirc_rpi registered at minor = 0
lirc_rpi: driver registered!
lirc_rpi: auto-detected active low receiver on GPIO pin 18
init: xbmc post-start process (1322) terminated with status 1

is result of your manual modprobe or ins mod action?

This is from my manual modprobe.

My IR receiver is not USB but GPIO connected.