Can't boot after adding exfat hdd to fstab

[Dr_Radar]

Xbian 1.1 Alpha 8Gb Sandisk drive

Just had same problem. Was adding external drive in the fstab using its UUID and Xbian then refused to fully boot. It showed splash screen at start but didn't finish booting and I couldn't SSH into it.

Any solutions found to avoid this?

(3rd Jul, 2013 09:48 AM)I_scoff_cake Wrote:  Xbian 1.0 Alpha 5.0 with all updates
Sandisk Ultra 30MB/s SDHC Card 8GB

Two times I attempted to put an exfat mount config in fstab and both times it wouldn't get past the load screen when I rebooted. I tried booting with no USB devices connected even. Both times I had to re-install Xbian on the SD card. Works fine with no exfat line in fstab.

I can't be bothered to troubleshoot it further because I'll just use the Wi-Fi to afp the files over instead of a hard link.