Wlan0 -10

[blueoval]

(30th Apr, 2014 01:49 AM)IriDium Wrote:  Can you post the output of dmesg and xbmc.log via pastebin

Also post /etc/network/interfaces from working and non working. (Check password is correct)

What is the SSID of your WIFI?

Can you ping your PC from the RPi?

What does the title mean? Wlan0 -10?

wlan0 -10 ... that was the message that came up in the xbian network screen after putting in wifi password.

I bobbled back and forth trying to get it to work and ended up trying and older version of xbian and had no issues. Eht0 good and Wlan0 conncected.

Did xbian 2.0 all over again with no luck. Just noticed this morn in xbian config (while in xbian i click on exit to get to config screen) wlan0 doesn't show ip address for some reason where the older xbian version did. It detects the router but wont connect. eth0 shows ip no problem.

I would need a little guidance if you want to see logs. Havent had to get this deep into it before. I'm trying what I can think of but Beta 2 not worky for some reason.