CEC not working at boot on Panasonic Viera

[Exnor]

(9th Mar, 2015 08:41 PM)Fabio72 Wrote:  But when CEC starts, then is perfect.
When I reboot Xbian, even with TV on correct input, I have to disable e re-enable link from TV to get it working again.
It's a bit annoying. Luckily I don't have to reboot Xbian very often. Only if evil devs are doing their magic too fast

When I started using Xbian, it was beta 2 and CEC was working out of the box, at every boot, with the same hardware and cables.


I use the last one, "Setup", then the first one of the following menu (I don't find a picture).
Viera link gives me error of no link found.

I think there could be different versions of TV firmware around.

I have a similar problem with LG Simplink (the equivalent to the CEC extended protocol used by Panasonic) and the solution for me was very simple... I've disabled Simplink.
CEC standart now works fine...

But i think this is something that is not equal to all models, because my bedroom tv is also LG but a different model and when i disable Simplink, CEC stops working altogether (and i suppose that is what was supposed to happen in all models).

Long story short rPi CEC and LG Simplink dont get along very well.... And you might have z similar situation there.