Migration from Rpi1 -> Rpi2

[Skywatch]

One thing I did think of was that kodi overrides the initramfs setting in boot/config internally (remember setting it to 'always' in kodi menus).
Do you know where I can change this as I expect it to interfere when trying to boot without initramfs.

update... I tried it anyway and now it does not boot. Just get a flashing underscore in the top left corner.

I have removed the SD card and am wiping it completely and then re-install the rpi1 image and try again. May take some time though....

Here is cmdline.txt...

Terminal

telnet zswap.enabled=1 zswap.compressor=lz4 console=tty1 root=/dev/mmcblk0p2 rootflags=subvol=root/@,autodefrag,compress=lz4 rootfstype=btrfs rootwait logo.nologo quiet noswap loglevel=0 partswap startevent=mountall selinux=0 splash nohdparm net.ifnames=0 biosdevname=0 --startup-event mountall

Seems that removing initramfs from /boot stops it even getting to splash screen. Going back to initram I get a message to press shift before the splash appears. Even doing this it hangs at 'loading' screen. Maybe it's better to start from scratch now?

and config.txt...

Terminal

#initramfs initramfs.gz 0x1500000
gpu_mem_1024=256
gpu_mem_512=144
gpu_mem_256=100
initial_turbo=3
hdmi_ignore_cec_init=1
hdmi_force_hotplug=1
disable_overscan=1
disable_splash=1
dtoverlay=hifiberry-dac
dtparam=i2c_arm=on
dtoverlay=i2c-rtc,ds3231
decode_MPG2=0x73c4f0f6
#dtoverlay=lirc-rpi
arm_freq=700
core_freq=250
sdram_freq=400
over_voltage=0