Migration from Rpi1 -> Rpi2

[Nachteule]

(3rd Sep, 2017 10:40 PM)Nachteule Wrote:  

(3rd Sep, 2017 10:25 PM)Skywatch Wrote:  I hope no Alzheimer too, a hangover though I do have

Added rescue but no change. Tried holding down both left shift and right shift (even space bar), but still goes as far as loading and halts once the bargraph has completed slowly.

FWIW heres the new cmdline.txt.....

Terminal

telnet zswap.enabled=1 zswap.compressor=lz4 console=tty1 root=/dev/mmcblk0p2 rootflags=subvol=root/@,autodefrag,compress=lz4 rootfstype=btrfs rootwait logo.nologo quiet noswap loglevel=0 partswap startevent=mountall selinux=0 splash nohdparm net.ifnames=0 biosdevname=0 --startup-event mountall
rescue

That's weird
Rescue mode is started always, I do not have to hit any key, and even after removing root fs (my dev sys is on USB disk) rescue mode is there

Btw, do you have wired of wireless keyboard? I was reading long time ago that the shift key only works with wired keyboards

Just FYI:

Holding down left shift (yes, only left shift does it) to enter into rescue works again.

This issue was one of the most annoying mystery in the past