[SOLVED] Wifi works, doesn't find network

[Ichalex]

Code:

wlan0     IEEE 802.11bgn  ESSID:"dlink"  Nickname:"<WIFI@REALTEK>"
          Mode:Managed  Frequency:2.457 GHz  Access Point: 28:10:7B:F1:5F:A6
          Bit Rate:150 Mb/s   Sensitivity:0/0
          Retry:off   RTS thr:off   Fragment thr:off
          Encryption key:****-****-****-****-****-****-****-****   Security mode                                             :open
          Power Management:off
          Link Quality=100/100  Signal level=90/100  Noise level=0/100
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

Edit: aaand it's gone. We'll not entirely, airplay still worked. but theres no internet access. but thats only an issue on the rpi, not on the other devices. here's the network status:



Edit2: I turned off my tv, and heard music over AirPlay. Then it stopped. I turned on the TV to check network status and it says busy on MAC address and Internet connection. Then I wait, and it gets a Mac adress, then it's busy again, as I'm writing this it's entirely connected again. Maybe it's because of the CEC of my tv, that sends Xbian into suspend? I know that on openelec, you can change the CEC behavior of Xbian. I will try to disable CEC and try again.


Edit3: disabled CEC, so far so good. Discovered the CEC config screen, it was set to ignore when turning of the TV. Strange. Now I enabled CEC...see how it goes