[blamaster]

I really dont know what im doing wrong but i cant get the beta 2 running for more than 3 minutes.

The first thing i did was a clean install of beta 1 with a successful update an upgrade to beta 2. This way xbian was really usable and fast. The only thing that was not working was the xbian config plugin so i had to setup my wifi with the ssh config tool.

Because of the broken config plugin i made a clean install and used the latest beta 2 image.

I have reinstalled the beta 2 image now for more than 6 times with the following reults:

1.) boot until "FS RESIZE" -> freeze
2.) boot successful -> the "first configuration" window comes up -> click on "Manage Networks" -> freeze
3.) boot successful -> skip "first configuration" window -> go through settings -> Xbian -> freeze
4.) boot successful -> skip "first configuration" window -> go through settings -> Xbian -> network -> wirless -> ssid -> ... it finds my network -> click on network name -> enter password -> loop through the window where i can select the network name. It wont accept the password the only thing i can do is exit the window but then it went back to eth0
5.) perform step 3) or 4) exit the xbian config plugin and try to open the config menu again -> "plugin already opened" (cant remember the exact error message)
6.) Try to shut down or reboot the pi with the xmbc power icon -> CEC disconnects but the image still stays on the screen and the pi wont reboot or shutdown
7.) If i try to do a hard reset (disconnect power) or sometimes after a fresh and clean copy to the sd card the following massage appers "Mounting root partition /dev/mmcblk0p2 failed" and "can´t access tty; job control turned off"