[mk01]

(26th Nov, 2013 07:44 AM)calisro Wrote:  Here is a dmesg after a DDing the image and a boot. /home didn't mount and I can see errors in dmesg. What do you think? If I issue a 'mount -a' it mounts though which is interesting. Sure seems like corrupted SD card but I never had a problem on 1.1 even if I DD my old backup image back and run that for a while.

http://pastebin.com/8jnuqt61

@calisro

can you try removing "smsc95xx.turbo_mode=Y" or even "elevator=cfq" also from /boot/cmdline.txt before first boot and try booting?

---

(27th Nov, 2013 10:54 PM)Swift Wrote:  after updating from 1.1 to Beta 2 I cannot access xbian-config from within the gui any longer (works via SSH). The loading screen of xbian config crashes exactly at 28% (I think it says "reading packages" before crashing). Any ideas?

this is caused by not being able to refresh packages list. I suppose your /etc/apt/sources.list files contains line

Code:

deb mirror://apt.xbian.org/mirror.txt wheezy main

?

if yes, can you change to

Code:

deb http://xbian.brantje.com wheezy main

and re-try ?

if still crashing, try from within ssh session

Code:

sudo xbian-config packages updatedb

fix for this case is included in xbian-package-config-shell package currently available on devel repo at http://xbian.brantje.com/pool/devel/main/x/xbian-package-config-shell/xbian-package-config-shell_2.1.6-52a_armhf.deb .

if you would like to test the fix, you can install that package by

Code:

sudo -i
cd /tmp
wget http://xbian.brantje.com/pool/devel/main/x/xbian-package-config-shell/xbian-package-config-shell_2.1.6-52a_armhf.deb
dpkg -i xbian-package-config-shell_2.1.6-52a_armhf.deb

then you should be able to start xbian-config-xbmc normally.

---

(28th Nov, 2013 03:58 AM)xuser Wrote:  Anybody else having problems with audio/video sync? For me it goes out of sync when I hit pause and then resume play. When I hit stop and then resume where it left off there is no issue. I did not have such problems with beta 1.1. I did a clean install because upgrading didn't work.

@xuser

what is your setup? hdmi or analog audio? audio passthrough with AVR or directly connected to TV. is it related to video files of specific type only, or general for all (audio as DTS, DD, AAC or MP3)?

more info would be appreciated. also, will this out of sync situation correct itself during playing rest if the video or it stays constant? approximately how much is it out of sync (x0 ms, x00 of ms or even seconds)?

(maybe can you test newer RPI firmware available at devel repo? you can install it with following steps:

Code:

sudo -i
cd /tmp
wget http://xbian.brantje.com/pool/devel/main/x/xbian-package-firmware/xbian-package-firmware_1.4-8a_armhf.deb
dpkg -i xbian-package-firmware_1.4-8a_armhf.deb