[Davem]

(16th Feb, 2014 05:16 AM)Baz8755 Wrote:  

(16th Feb, 2014 05:13 AM)zilexa Wrote:  I did a clean install of beta 2 using Windows installer. During the first start wizard I chose Update. The process ended with an error (screenshot will be added). Then I was asked to reboot. Now, it has shown "starting xbmc..." For 7minutes, sometimes the screen goes black and then back to the "starting xbmc" screen.

Too bad, it has been over 2months since I did a clean install. This shows me xbian is still not stable enough, a simple clean install should at least work, right? I didn't overclock or do anything.

I had similar problems on a clean install, using SSH I had to install all updates and reboot twice and now all is good

I also had the same problem. Yesterday I've done a fresh install of beta 2 and installed all the latest updated by SSH xbian-config. I was facing two (known) error's. If you continue updating by SSH Xbian-config it turns out okay. I hope this will not scare of new users..

My install steps on a fresh beta 2

Beta 2 is running very stable now.